Kinetics | Metal Injection Molding

MIM 4605 Case Hardened

Material Properties	Kinetics
Material Properties	Typical 2
Ultimate Strength (KSI)	-
Yield Strength (KSI)	-
Elongation (% in 1")	-
Reduction in Area (%)	-
Surface Finish (Ra)	40
Impact Energy (ft-lbf)¹	-
Macro Hardness (R15N)	88.3
Sintered Density (g/cm³)	7.6

¹Test method uses 1/2 sized un-notched charpy bar.
² Typical values at a hardness of 47 HRC. Higher hardness and strength characteristics can routinely be obtained through varying Quench and Temper conditions

Material Description:
Low alloy steel, carbon, nickel, molybdenum. A multipurpose, economical material that offers various strength, hardness and wear resistance properties depending on whether it is heat treated and which heat treat process is used. Magnetic. Can be plated or coated for corrosion resistance. Used by a very wide range of industries including automotive, consumer products, firearms, power hand tools, structural and applications where good strength, hardness and wear resistance are required.

Material Composition (%):

Fe	Ni	Mo	C (Max)	Si (Max)
Balance	1.5-2.5	0.2-0.5	0.4-0.6	1.0

Click Here to Print This Page